Researcher and Honeywell Dispute Impact of IQ4 Controller Vulnerability

· Original article ↗

Summary

Researcher Gjoko Krstic says Honeywell IQ4 controllers may expose an unauthenticated HMI and allow early administrator-account creation. Honeywell disputes the risk; SecurityWeek confirmed many interfaces are internet-exposed but not the other claims.

Key points

  • Krstic says the IQ4 controller’s web-based HMI is unauthenticated in its factory-default configuration.
  • He says an attacker with access to the management interface could create an administrator account before legitimate users do, if setup is incomplete and a user module is not enabled.
  • Krstic warns this could lock legitimate operators out; he also says he could change building-control components in some installations.
  • Honeywell says the scenario is limited to a brief installation phase or deliberately disabled security settings, and says a standard reset resolves installation issues.
  • Krstic estimates nearly 7,500 instances are internet-exposed and about 20% are accessible without authentication. SecurityWeek confirmed many exposed interfaces but did not verify the other claims.
  • Honeywell is apparently not issuing a patch, and a CVE is pending.

Article Details

Vulnerability Types
  • Unauthenticated access to the web-based HMI in the factory-default configuration
  • Remote creation of an administrator account when the product is improperly configured and the user module is not enabled
Severity
The researcher characterizes the vulnerability as high risk; Honeywell disputes the severity and operational impact.
Exploitation Status
unknown
Exploit Availability
unknown
Patch Status
unavailable
Workarounds
  • Do not expose IQ4 devices to the internet, as Honeywell recommends.
  • Configure the device using normal installation processes with security enabled and the user account set up.
  • Use a standard reset to resolve an installation issue, as Honeywell stated.

MITRE ATT&CK

People

Vendors

Products

Industries